Please use GoodSearch for your internet searches and select a charity (such as Dominican Sisters of Houston). Thank you.

gate results

Sunday, June 14, 2009

The J-B Weld seems to be holding for now. This was the second application. On the first application, the J-B Weld pulled the surface treatment off the brick. There's a layer of something on the brick to give it its texture; that came off. So I re-applied the J-B weld to the same spot now that it's cleaned off, and it seems to be holding. The close-up shot shows a failed attempt below it; I had tried some other epoxy before and it didn't work.

Actually, when the J-B Weld didn't work the first time, I attempted to drill into the brick so that I can set an anchor for a screw. After about an hour and I'd gotten only maybe 1/4 inch into the brick, I decided that J-B Weld was worth another try.


That might be too big a job for the one bracket and one screw into the post. I might go find another bracket that would allow me to put two screws into the post and add it.

I've discovered that I need a handle on the inside too, since the gate needs a slight lift into the paddle latch to close. I had positioned the latch to support the gate (not just capture it). Perhaps I shouldn't have, but it's done. It has definitely been a learning experience.

0 comments: